[PC-BSD Testing] Error message while booting

[A.Yerenkow]

On 10.03.2009 21:10, Bill Leeper wrote:
> Kris, I am getting a strange error message when booting. I have
> checked dmesg and it is happening after that log stops recording. It
> says "The following disk sectors can not be read" and then lists four
> or five sectors. These sectors are near the end of a 400GB drive and
> have no data on them. I don't know if you are familiar with a program
> called Spinrite, but running it on the section of the drive containing
> these sectors comes up with no problems on the disk. If Spinrite says
> the sectors are good then I would bet the farm that they are good.
>
> The system does boot just fine and I had noticed the message earlier
> but did not have time to check it out.
>
>
>    
Is FS journalled?

> 
> Computers can be fun again
>                   format C:\
>     Alternatives are out there
> 
>
> _______________________________________________
> Testing mailing list
> Testing at lists.pcbsd.org
> http://lists.pcbsd.org/mailman/listinfo/testing
>